M4wdriveway Yota Exo

[etk300ex]

Any cheap filter I see is "Not For Fuel Injection".  What are you running?

[mr.mindless]

Coarse prefilter, fine after filter.

[M4wdFab]

most cheap anything filters are 5-15um put one before the pump.  The pump is what you need to worry about the the injectors.  the injectors have there own 30um filters and wont care.  if your pump is graveling enough to clog the injectors you have failed already

[etk300ex]

new trailer ubolts

[etk300ex]

axle bendage, see gap at bottom of drop

[M4wdFab]

we could probably fix that axle with the pipe bender and my digital level on the lift.....

[etk300ex]

I couldn't think of a way to get 3 points on it to bend it in the correct location, but I'm sure we can figure something out

[M4wdFab]

why dont you drop your trailer off so i can use it to scrap this week, and ill bend your axle back.  its just the one axle right?  so i could match it up to the good one.

[mr.mindless]

Is that really something like a quarter inch difference?

With movement there it wouldn't be bent tube it would be bent drop or spindle wouldn't it?

[M4wdFab]

ya bend drop bend thingy, doesnt matter.  doubt the spindle is bent, it would be chewing bearings, spitting grease ect. 


put the pipe bender in the center of the axe and bend the middle up

[cracker]

but that is going to effect both sides, this pict looks like it is the drop that is bent

[M4wdFab]

unless its fixed it self since last year, both front axle tires were tipped way out at the road.

[etk300ex]

Just the one sides bent

The rear axle looks like the drop was cut off and welded back on, its about an inch narrower than the front too

[etk300ex]

I need it to help somebody move saturday .  I can swing it by sunday or next week. 

[M4wdFab]

if only one side is bent i cant help you


get rid of that pile