new house for mikemike

[M4wdFab]

im still just using the drum taps i made for KOH fuel, just put a drum sideways on my chassis table and dispense as needed. 

[mr.mindless]

Yesterday morning and this afternoon

[mr.mindless]

I need to turn my sketches into drawings for some peer review but I think I settled on what to do for tire storage, and decided on a final axle rack design. Hoping it works out such that I have a good position on the rack to work on an axle out of a car too.

34” or so seem like a good support width?

Does putting 9-10 axles on one side of a pair of vertical 4” channels seem sketchy, weight wise? Ladder type setup. Sitting on concrete at the bottom and top tied to a building beam with some wall support tie in as well.

[M4wdFab]

what could possibly go wrong

[mr.mindless]

idk, if it's full of D60 steer axles fully dressed it could get a lil heavy. but steel is pretty ok in compression. A support in the middle and an X brace should keep it in compression instead of some other shape. I hope.

[M4wdFab]

take pictures and list them for sale.  sell 3 of them and scrap the rest.  you will feel better about it.  haha

[Wingman]

I'd be interested in a SD60 99-04 if you've got one...

[mr.mindless]

no super duty stuff. older BJ ford/dodge things, late model e250 semifloat rear, and that mostly covers it.

[TrailTamer]

99-04 Ford & 94-99 Dodge D60s use same inner Cs.

I’ve been meaning to ask if I can have the bare Ford D60 I gave you years ago back... if you have no plans fir it

[mr.mindless]

Did the initial dose of blue. Figured at the sump outlet would spread it pretty good.

[dubt]

Stuff works great at our camp.

[M]

Do you have a lot of water runoff through that pond when it rains hard?

[mr.mindless]

Early in The season when the water is high, yes.

[mr.mindless]

I need shittier property to motivate any shop work. Beverage out of shot.

[etk300ex]

that does looks pretty nice!