have building some spare drive shafts in the back of my mind since even though i have been through a lot of iterations of improvement- they still seem to be one my my common failures.
mid shaft in the car is a good spare, but it has a slugged section, with the failure of plug weld designed removed. i have 3/8 wall DOM to replace it but having a hard time coming up with a way to adapt while maintaining strength. have a few 60 pinions laying around, 1350 yokes are 50$ each
im tempted to go back to original 2" 120 wall tube to 14bolt yokes, with a slug of 7075 inside of it to keep bending down
