Projects place > Projects Section
572
M4wdFab:
JJ had a housing and I ran out and grabbed for 100$ credit on bill due for brolite gear work :)
same housing, but in the end decided to slug on just a spindle. hard part done, just need 4 tabs back on and reassemble.
M4wdFab:
what could possibly go wrong
Wingman:
Never considered a āZā cut on a tube. Smart!
M4wdFab:
ya figured anything i could do to make this stronger should be done. the slug is thin wall to not block oil to the hub and not really structural more for alignment. i sectioned it in the middle there also because the tower for the track bar and bump pad straddles that area and will add a ton of structure.
hopefully will be a non issue and be good for years more of service.
M4wdFab:
finished this up and back to used up race car status
bah.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version