Projects place > Projects Section
572
M4wdFab:
Just thinking aloud....
if i get two fabricated 9 housings one off set to the left and one off set to the right, i can build any off set diff car, front or rear engine, passenger diffs or driver diffs on both sides.... hmmm
mr.mindless:
offsetting both diffs?
isn't the 9" pattern reversible, too, so there is no right or left drop, just an offset (ignoring drain and fill holes I guess)
M4wdFab:
thats what im forgetting, if the pattern is flippable, ill have to look into that.
big choice is going to be spendy light 9's or do 14's i have to do some reading on both, but one will happen.
ya i was thinking pass diffs but after Ryans comment nothing says i couldnt flip the other 60 i have, weld on solid C's corrected and run it. new car will stay 4.10s in 1:2 70-80mph is plenty fast in the rocks :)
mr.mindless:
lots of load on 4.10s apparently? can't believe Rywan's broke.
jacel86:
The TrueHi9 is one I always thought looked damn good. Prices are rough though as expected.
Navigation
[0] Message Index
[#] Next page
Go to full version