M4wd&Fabrications

Projects place => Classifieds => For Sale => Topic started by: TrailTamer on July 30, 2018, 10:56:55 AM

Title: 5.3 & engine wiring harness w/ pcm
Post by: TrailTamer on July 30, 2018, 10:56:55 AM

5.3 unknown condition, I was told it have 97k miles and came out of some early 2000’s avalanche (2003?). No alternator, a/c compressor & exhaust manifolds, otherwise complete.

Full engine wiring harness w/ pcm out of an express van with 6.0, drive by cable If I remember correctly

$500 take all, including the engine stand.

Title: Re: 5.3 & engine wiring harness w/ pcm
Post by: M4wdFab on July 30, 2018, 11:52:08 AM

coil packs and starter motor? Maf?

is the harness cut at all (including trans plugs)? 

Title: Re: 5.3 & engine wiring harness w/ pcm
Post by: mr.mindless on July 30, 2018, 12:35:08 PM

I have 2 full sets of coil packs, and I think 2 spare MAFs (don't remember if I had to use one of the 2 I had for new motor or not but I could certainly spare a set of coil packs if needed)

Title: Re: 5.3 & engine wiring harness w/ pcm
Post by: TrailTamer on July 30, 2018, 01:24:56 PM

I need to check on maf. I have coil pack. I believe starter is somewhere, I’ll need to look.

Wiring are all there afaik. I can check.

Title: Re: 5.3 & engine wiring harness w/ pcm
Post by: TrailTamer on July 30, 2018, 01:26:36 PM

I looked up some old PMs (2012) and confirmed, the engine wiring harness came out of a 2003 Chevy Express 6.0/4L80E