M4wdriveway Yota Exo

[M4wdFab]

he has a CV at the case, and 25 degrees at the diff unjoint

[etk300ex]

Prolly more like 45 lol.  What if I just put a reg joint in?

[M4wdFab]

reg joint would get case and diff closer to sync, if it will take the current angles

[etk300ex]

Whats up with my steering.  steering wheel turns and wheels dont.  Pump shitting the bed?

[mr.mindless]

steering valve shitting the bed. if it was fluid starved but otherwise good it should be hard to turn.

[etk300ex]

orbital should be the only good part of the steering system...

[M4wdFab]

wrong ram, shaft is way to big.  i suspect air in lines also.

[JEEPWERX]

Maybe it's pissed that you took it out of the garage? LOL
my CJ steering would get cranky after sitting for long periods. But always seems to clear it self after some driving.
Is it worth fluid replacement?

[etk300ex]

wrong ram, shaft is way to big.  i suspect air in lines also.

You told me to get that one lol.  Idk its been bleed pretty thoroughly.  This is a new symtom, before it just wouldn't turn at low rpms.

[etk300ex]

2X6X1.25 DA HYD CYL SWIVEL EYES I believe this is the unit I have

http://www.surpluscenter.com/Hydraulics/Hydraulic-Cylinders/Double-Acting-Hydraulic-Cylinders/2X6X1-25-DA-HYD-CYL-SWIVEL-EYES-9-7259-6.axd

1.25 seems to be pretty common shaft size at 2".  What were the single ended ones you guys were running? or were then 2.5"

[mr.mindless]

Trapped air would surely do it.

Raise the front tires off the ground. Bring it lock to lock 3-4 times every time you're out in the garage over a week. Ought to bring any air out easily.


Tapatalking in traffic

[M4wdFab]

got bleed air at the ram with that ram up, the volume of his cylindar is way to small

[etk300ex]

I will try it again

[etk300ex]

What did/are you guys running for SE cylinders?  2.5 x 1.25?

There only like $60 I'll get another and dump this one lol

[etk300ex]

a non swivel eye cylinder would also semi-fix my tie rod problem.