M4wdriveway Yota Exo

[etk300ex]

and I need this to happen in a spot where it wont roll away and hope it diesels long enough that I can perform these many tests fml 

[mr.mindless]

That banjo bolt is probably $15-20. Remember my other thread looking for the compression fitting.

Get a size and thread pitch? I'll probably just order one, maybe I can find a vendor that has what we both need.

[etk300ex]

wh wait

cold start injector? huh?

On older fuel injected engines, a separate "cold start" injector is used to spray additional fuel into the intake manifold when a cold engine is first started

fawkin noob

[etk300ex]

the banjo bolt itself can be had for $30 shipped

[M4wdFab]

wh wait

cold start injector? huh?

On older fuel injected engines, a separate "cold start" injector is used to spray additional fuel into the intake manifold when a cold engine is first started

fawkin noob

Cold start injectors have been my life for the last 4 years.....  that is not a cold start injector, that's an emmissions nightmare 

[luvmyxj]

having my own problems id start with the fuel pressure .is it possible some of that foam got by the filter and clogged somewhere

[etk300ex]

this pops up every once in a while http://www.actron.com/product_detail.php?pid=16288

but the consensus seems to be buy it from LCE cause you wont find elsewhere

[etk300ex]

having my own problems id start with the fuel pressure .is it possible some of that foam got by the filter and clogged somewhere

doubt it, it ran for a year after that and my filter screen is like 0.0001 microns

[etk300ex]

Some indicators of a fuel related problem would be:

• Lack of power going uphill or when pulling a load

That me!!!

[M4wdFab]

could be too much fuel, ya i think i fuel pressure gage would be a good idea

[Nick]

Load this and the Dakota on the trailer and scrap them and then take that money to the casino and double it!!

[mr.mindless]

I think nick has a solid point there.


Tapatalking in traffic

[etk300ex]

going to order the gauge, i dont have time to dick around finding adapters.  plus I could probably sell it for at least $50 if needed lol

[luvmyxj]

Any rubber line you can tie into,after promo the one at advance was like $10 and about $10 in fittings

[etk300ex]

i want to see pressure in the rail