Willys MB build

[Ryan]

I am an Artec dealer, Get a discount. I can get you a price if you want to throw out the part numbers.

[Harrison]

Dan does PSC

[Wingman]

PSC FHK100P trail series 2.5" kit w/P-pump, no mount opt, no cooling opt
(2) PSC SCCL04 ram clamps

Artec HS6020 - Ultimate D60 high steer arms
(2) Artec HS6081 - D60 knuckle bolt kit

[Wingman]

What thickness aluminum sheet are you guys using for tins?

[JEEPWERX]

I did my floors, firewall and plan to do roof in .125" (1/8")
 dash, side tins are .0625" (1/16")
Ryan or Smike had mentioned having used a more pliable aluminum product. The materials pacemaker sold me was not easily bent.

[M4wdFab]

the roof on 571 is a stiffer higher cost grade.  much better.  572 and 928 roofs are pretty soft 6025 i think or 6018 sounds right.  else what erik said

pipe insulation by the roll 2" wide in the places where tubes touch will keep the rattle down

[JEEPWERX]

I used foam weatherstrip. Sticky back  in various widths depending on where it was needed. So far so good.

[matt]

I used foam weatherstrip. Sticky back  in various widths depending on where it was needed. So far so good.

That's a good idea.

[M4wdFab]

6$ for a 30' roll of plumbers tap.  the stuff at depot is fiber rienforced and a little stronger.  its 2" wide, and sticky on one side. 

[rejeep]

dynamat or cork tape

[JEEPWERX]

Dynamat is next on the list for me. Buggy is hot now in the summer with all this aluminum.  Prob be nice in cooler weather

[Wingman]

PSC kit arrived today.

[JEEPWERX]

Ooh yea

[jaysenodell]

If only there was a front wheel holder ...

Wish I was able to drool over this in person. Next time I'm up we will have to weld or cut something.

[Wingman]

Passenger side upper, lower, track bar link mount.  Tucks just inside the frame rail.  May be trimmed later.