Projects place > Projects Section
One last time, BANG
M4wdFab:
--- Quote from: M4wdFab on August 09, 2012, 05:19:05 PM ---race prep?
--- End quote ---
what's gotta get done?
I also just posted on FL asking about departure plans...
[/quote]
(1)I have been toying with throwing the PSC ram on for this race, but leaving the mounts for both. Everything would swap back and fourth to a new car, or its only 300$ in parts meh.
(2)id like to pull the front shocks and put them on the rear, put the new shocks on the front
(3)Front driver bump pad deserves an extention
(4)wash job / new profender decals
(5) mount extra yellow top
(6) fluids changes
(7) check both front king pins / weld up passengerside also
(8) front tool bag mount
(9) mount new highlift
(10) check front shaft everything
(11) grease job
(12) wheel studs
Ryan:
Do you want me to check what springs I have, replace some bent ones?
M4wdFab:
have any 250 or 300;s in lower coil size for 14"S?
Ryan:
I have 250 300 and 325
M4wdFab:
--- Quote from: M4wdFab on August 10, 2012, 01:03:21 PM ---
--- Quote from: M4wdFab on August 09, 2012, 05:19:05 PM ---race prep?
--- End quote ---
what's gotta get done?
I also just posted on FL asking about departure plans...
--- End quote ---
(1)I have been toying with throwing the PSC ram on for this race, but leaving the mounts for both. Everything would swap back and fourth to a new car, or its only 300$ in parts meh.
(2)id like to pull the front shocks and put them on the rear, put the new shocks on the front
(3)Front driver bump pad deserves an extention
(4)wash job / new profender decals
(5) mount extra yellow top
(6) fluids changes
(7) check both front king pins / weld up passengerside also
(8) front tool bag mount
(9) mount new highlift
(10) check front shaft everything
(11) grease job
(12) wheel studs
front axle seals
reset front diff preload
steering fixed way better, i think it might last more than a lap tight
[/quote]
Navigation
[0] Message Index
[#] Next page
Go to full version