front 14 bolt build

[M4wdFab]

its time with only one more 5.38 gear set on the shelf.  not going to buy another 60 set.  no 70 set available so 14 time. 

i have looked at drop out options. cost is high.  i dont see a need for anything more than a stock center section.

Hopping Cora can broach a couple 14's with 35spline 60 holes and keep the RCVs for now.

spin up a set of seal boars, new solid C's, swap everything and truss up an axle with tabs. 

for 500$ and a weekend i should be in.

[M4wdFab]

new pair of these bored out to 3.25"
http://solidaxle.com/ProductCart/pc/viewPrd.asp?idproduct=42&idcategory=8

[mr.mindless]

Running backwards, I wonder if you will have better luck than with 60 stuff or not.

I think pinion offset from axle centerline is different, you're not too tight on clearance up front though, that should be fine.

I just wonder how much of an upgrade it really will be. Shame no 70 sets around, I really think that would be a better option.

[KingtheZJ]

no 70 set available

what do you mean?
no gears available?

[M4wdFab]

5.38 gears are not an option for D70.  D70 spools are also about 600$


My 14 running backwards in the rear could give a crap about anything i have done to it.  its was run in 571 for 3 years before 572 also. 

[mr.mindless]

fair enough!