On replacing the 1" shank front Johnny joint I broke:
1" heims seem rare. Cost the same at speedway as 1.25s, just under 50ea.
Could toss a pair each in front and rear with standard misalignment spacers to delete Johnny Joints.
Have to do work on links to delete bushings, which I would like to. Could remake with any thread I want. 7/8 seems right for uppers but I already broke a 1" JJ shank. So either 1 or 1.25 it is. There are wide misalignment spacers that take up space to go into a 3" bracket that matches my bushing width, but I doubt the hole spacing will clear the body of a heim. I found one listed dimension that gives a 1" heim a 2.75 body; bushings are in 2" tube.
Standard misalignment is 2 5/8 wide so I only have 3/16 on each side to just sandwich something in. Probably need to bite the bullet and just build new frame side brackets. Bah. Probably replace the front-fronts with 1" now and leave the rest for later.
Tapatalking in traffic