M4wd&Fabrications
Projects place => Projects Section => Topic started by: M4wdFab on September 02, 2015, 09:45:43 PM
-
its time with only one more 5.38 gear set on the shelf. not going to buy another 60 set. no 70 set available so 14 time.
i have looked at drop out options. cost is high. i dont see a need for anything more than a stock center section.
Hopping Cora can broach a couple 14's with 35spline 60 holes and keep the RCVs for now.
spin up a set of seal boars, new solid C's, swap everything and truss up an axle with tabs.
for 500$ and a weekend i should be in.
-
new pair of these bored out to 3.25"
http://solidaxle.com/ProductCart/pc/viewPrd.asp?idproduct=42&idcategory=8
-
Running backwards, I wonder if you will have better luck than with 60 stuff or not.
I think pinion offset from axle centerline is different, you're not too tight on clearance up front though, that should be fine.
I just wonder how much of an upgrade it really will be. Shame no 70 sets around, I really think that would be a better option.
-
no 70 set available
what do you mean?
no gears available?
-
5.38 gears are not an option for D70. D70 spools are also about 600$
My 14 running backwards in the rear could give a crap about anything i have done to it. its was run in 571 for 3 years before 572 also.
-
fair enough!