Chassis table built. Finally able to lay some stuff out and start visualizing.
Pics are at 22" belly and 20" axle tube centerline. Belly height is subject to change a little. Front driveshaft pictured length will be about 24", more or less planning to have to run one of the Tom Woods offset u joints at the output like I do on my Jeep.
Legroom is going to be at a premium. Doghouse will need to be well insulated.
Working on an output solution that mates an 8.8 flange to the VW flange via TIG weld after a little lathe time on the 8.8 flange. Planning to run single joint 1310s all around, have held up well on my Jeep and I don't expect more abuse on driveline parts than my pig of an XJ. I'd also rather snap off the shelf stuff like that over obscure transaxle parts.
Seats are on their way. Hopefully ordering tube this week, Dan is working on gathering people for a big order.