Finally got back on this thing in the last few weeks.
Shock mounts are set front and rear after a couple iterations of each. Major tire/shock/steering arm clearance issues on the first couple tries.
Rear chassis section finished.
Caught up on chassis welding without flipping it over.
Next steps:
Roll it outside on 39s and see how it looks. Need to finish up the H1 project so I have something to put on my Jeep.
Unbolt axles and pull drivetrain and do a whole bunch of welding.
Source some 3/16" AR plate for belly and get that welded on.
Reassemble
Hydraulic system, plan to go with Radial Dynamics stuff
Electrical system... big one. Have a vendor that can load the swap file into my ECU to delete immobilizer and evap stuff. Plan to send my harness out to them as well.
Shop insulation is amazing... R13 above R6.5 board. Little convection heater keeps it at 60 without issue on even the coldest days without the obnoxious noise of my old forced air unit.