M4wd&Fabrications
Projects place => Classifieds => Wanted => Topic started by: carchameleon on June 05, 2012, 08:39:22 PM
-
i think one of the times i had my engine out i cracked it...
anyone have a 258 oil pan?
-
what? you cant hurt a 258 pan, what is the real problem?
-
I have one...
Several...
But I agree with Smike..
-
i have a oil leak, it looks like its coming from the pan under the skid
still diagnosing, but figured i'd look for a pan
cleaned everything off and thats what it looks like
i'll clean it more and look again
-
they do rust through easy..
I had a pin hole in my original 60K mile YJ (1997) and it leaked like the Exxon Valdese
-
:withstupid:
I had a rusty one with holes on my CJ many years ago...
-
:withstupid:
I had a rusty one with holes on my CJ many years ago...
I still wish I would have taken a pict of the "official CJ parking spot" at my old house..
-
this was a new pan i put on the motor when i built it, doubt it rotted
-
that would be awful new to rot then. what, 4 years?
gaskets or mains would be more likely. wash it up and confirm where it's really leaking from.
-
i am calling user error and bad seal on drain plug
-
:withstupid:
I had a rusty one with holes on my CJ many years ago...
I still wish I would have taken a pict of the "official CJ parking spot" at my old house..
I think it was a different one than Pink...
-
drain plug is tight
i cleaned everything and took it around the block yesterday and it had a few drips when i stopped
this morning when i went outside there was (and still is) a big puddle of oil & no wet spots above the pan skid...
didn't get to look today
i'll look tomorrow am and see whats going on..
-
just looked at it
nothing above that skid is wet
not user error, asshole
i can diagnose a leak
[attachment deleted by admin]
-
haha ;D
-
sure not drain plug. but is it just the gasket or is it really the pan? I'd suspect gasket....
-
you need a 1 pc. rubber gasket, change the RMS while your in there...
and while the pan is off.... might as well take a good hard look at it..
-
you need a 1 pc. rubber gasket, change the RMS while your in there...
and while the pan is off.... might as well take a good hard look at it..
that was part of my plan
how much are the gaskets?
how much for one of your pans?
-
if you help Mike load a bike at some point today you can have the pan....
I have a feeling its a 2 man job, easier if one of those men knows how to opperate a motorcycle..
-
i would not F with the rear main on the motor, it has like 6K miles on it
i guess ill stop with my $0.02 :-X
-
Agreed on mains unless they're surely leaking.
-
ok, talking to mike now
-
i'm going to say the oil pan will fix it, when i take it off i'll look at it closer
arie, when are you around so i could pick the pan up
how much is a gasket from you?
ok if i grab your welder at the same time?
thanks
-
saturday noon at carter would be the one stop shop
-
ok, sounds good
thanks