Projects place > Tech

on board 1350 ujoint transport

<< < (2/2)

mr.mindless:
definitely would apply to both, similar problems.

if this were installed on the joint of a spare shaft during assembly and could just be around the 2 free caps that might be really fantastic (or much worse? but I think it would be helpful)

M4wdFab:
Matt now has 3 spare drive shafts affixed to his car for spares if needed.  the thought was to take a short 3-5" section of 4" diameter heat shrink and "vac pac" the ends of the shaft to contain the caps and make easy cut away for install when needed.


if the stuff we ordered is looking thin, we planned to double it up. 

M4wdFab:
new heat shrink worked awesome.  nice and thick.  looks good. 

17$ for a 4' piece

GBR928:
Link for the HD heat shrink material we used:

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F201930486545


Sent from my iPhone using Tapatalk

SB406:
Sweet! I'm ordering some.
My driveshafts sit in a toolbox in the tow rig, but this would still be useful. 

Navigation

[0] Message Index

[*] Previous page