tried installing a fuel gage on this guy-
sourced 2nd amazon gauge thats correct range, but still unsure if direction is correct. (high resistance is full or Empty)
lots of confusion today after installed, reads just over empty once powered. i had figured it was closer to 3/4 since i measured 220ohms at under hood connector. my research shows this year should be 50-250ohms empty to full
pulled a flatbed board and measured resistance right at sender to be 118ohm. bah
traced entire chassis wire loom, eliminated tank pressure ground splice and all other BS wires,l confirmed no issues tank plug to gauge.
plugged in to gage it reads 50 ohms mid harness
rambling and confused, i guess ill go pump 100$ and see what happens, bah/