4 links front and rear, all 38" is long
plan is links, subframe, axles, steering, drive shafts will all be symetrical / mirror image front/rear.
engine will be off set on right side, with transmission in center with ouputs point to front left diff and rear right diff.
fill the seat, cell, rad in where there is room, tube over top, wheel.
single ended 10" rams for 50 degree steering, leaving superduty tie rods ect for now
had thoughts to try and do pinion brakes but on the transaxle end, and remove all the superduty calipers/rotors but not seeing a way to execute that relistate wise up front (legs in way)
the fuel pressure is PWM'd on these things o need to deal with that... Fuel pump module scrapped with shell. hoping to use a corvette 58psi filter reg instead and run it