Projects place > Tech
drive shaft tech 1350
M4wdFab:
i found 3.25" OD x 2.81" ID x (.219 Wall) DOM on ebay for pretty good prices
also, seems Deny's drive shafts in buffalo has good prices and shows stock for online order.
i ordered new yokes, splines, and slip yokes to make two new 1350 drive shafts with 1.5" splines.
M4wdFab:
2 Dana Spicer 3-40-1611 SPLINE Fits 3 inch .083 wall tubing 1.5 inch Diameter with 16 Splines
Part #: 3-40-1611 $55.95 $55.95 $111.90
2 Slip Yoke 1350 series 16 spline NEAPCO 7.312 inches
Part #: 3333586 $49.95 $49.95 $99.90
2 NEAPCO N3-28-57 Weld Yoke 1350 Series to fit 3 inch .083 wall tubing
Part #: N3-28-57 $24.95 $24.95 $49.90
4 Dana Spicer 5-178X 1350 Series Greaseable u-joint
Part #: 5-178X $17.50 $17.50 $70.00
Subtotal: $331.70
Shipping (FedEx Ground): $22.15
Sales Tax: $30.96
Grand Total: $384.81
M4wdFab:
got a working FedEx tracking number in 74minutes. says tomorrow delivery. these guys dont mess around 8)
JEEPWERX:
Nice.
Thanks Smike
I will be ordering some parts to make front shaft. Rear is done.
Any thoughts on greasable vs lifetime Spicer joints?
I just pulled a lifetime out of Cora old rear drive shaft and it was in pretty decent shape for its age. Compared to a grease be joint that never gets serviced
gif:
Spicer non serviceable
Navigation
[0] Message Index
[#] Next page
Go to full version