Yup, pushed the skid down and she moved.
About 3.3" longer. need to move trans mount, mount pillow block off the side instead of flat while lengthening front shaft. Need to move case back, I was gonna cheat that tempermanently but it doesn't fit under the tube it's mounted from.
That technical drawing said how far back the mount is. Around an inch. The pan is also an inch longer so I need to move the mount for clearance, not just drill holes further back. It is also a rectangle, which eats driveshaft and bearing and bearing mount clearance.
It will be easy to go back to a TH350 should I need to - the carrier of a 1350 CV is almost exactly the right length for a mini shaft between trans and case after things are pushed back.
It's gonna be super tight to make this race. I HATE that. Tempted to call it off now just so I don't kill myself this week. I figure at best I have two full days of work and that's assuming I don't need to redo the floor and can just remount what I took out. Oh, wait. Moving the case. Whose mounts stick the rough the floor. Fuck.
Tapatalking in traffic