Just pulled back the 240v I’m not going to use. That all will get reused for the range, i think. They pulled (3) 8awg for the 240 plus a separate 12awg ground even though it’s all steel conduit and box to the steel panel box. Of all the rest that’s in steel, only the lighting contactor run has a ground wire.
I can push the (3) 8awg through the 3/4 conduit that is already run. I just pushed about 10’ of it. Not quite enough to get to the first J box, but around both bends, and it frees up by 1 wire after that.
I’ll match the 8 & 12 awg THHN that’s in use. No reason to adjust from a good thing.
Either of you have a conduit bender, or should I just buy the couple 90s I’ll need?