entire machine sprayed down with simple green and cleaned, slats pulled and needle scaled, flipped over. water table chipped out and vacuumed up. wired, and really got it semi going first try. little tweaking and learning and im off and going!
no complaints or annoyances with the lap top, runs crip and clean. I haven't tried to load up my LS PCM software yet but would be nice if it plays ok that (PCM hammer and Tuner pro) Flashing a PCM right now actually with another broken screened (mosty pink display now lol) lap top thats still barley kicking
i didnt look in to power feed back to much as i could only round up 1 of the 4 missing cables/plugs id need, so right now it just has initial height torch sense (which is really annoying to get to work right)
i kinda plan on buying a CNC ready higher amp plasma and just buy the cable that plugs in (or wolfi said he has a cable for me)
successfully cut out lower link chassis tabs out of 1/4" and have design work started for uppers. perfect timing as picking up the other SD60 tomorrow in niagara falls.